Savaria-Dent Fogók

- Tungsten-Carbide insert.
- For creating dimbles with different heights.
- The three variations height make three variations of arch shortening, with which we can easily close gaps (e.g. diastema), or we can even correct in the front arch, in asymmetric cases by creating compression in the desired spot.
- The line of the arch won’t change so it can be applied inside the mouth too.

- Because of the effective lever ratio, the arch won’t turn out from the plier.
- Torquing key designed for 4 arch thicknesses (.016” .017” .018” .021”).
- The result can be checked with the torque control board.

- For fine loops and bends.

- For fine loops and bends.
- For utility arches too.

- For bending wires and making helixes.
- Cylindrical nose part in order to avoid torsions.
- Optionally can be ordered with groove too.

- Similar to the Young pliers, but thankfully to its concave design it is more precise and holds the wire more firmly.

- Optionally can be ordered with groove too (SD 139/G).
- Because of the great holding force it is easier to make the wires and bends.
- Strong construction, even for 0,9 mm wire.

- Precise design for the correct torque control.
- Long lifespan even without carbide insert.
- Nose thickness: 1 mm.
- Short nose - stable grip.

- Precise design for the correct torque control.
- Long lifespan even without carbide insert.
- Two nose sizes in one plier.
- The outer nose part’s thickness: 0,8 mm.

- For creating a staircase shape on the side and guiding the down bend.
- Five vertical nose heights in one instrument with 1 mm steps.
- Rounded edges.

- Extra Fine max .014” (SD 200/XF)
- Fine max .016” (SD 200/F)
- Medium >.016” (SD 200/M)
- Technical max 0,9mm (SD 200/T)
- Appropriate for Ni-Ti wires too.

- For bending up the arch-ends behind the tube.
- Avaliable with Left (L) and Right (R) curve.
- Extra Fine max .014” (SD 200C/XF/L or R)
- Fine max .016” (SD 200C/F/ L or R)
- Medium >.016” (SD 200C/M/L or R)
- Appropriate for Ni-Ti wires too.

- Tungsten-Carbide insert.
- For bending steps.
- Can be applied inside the mouth too, as the parallelism remains after the bending too.
- Appropriate for steel wires up to .019”x.022”.
- Avaliable in six sizes from 0,4 mm to 0,9 mm (SD 104/0,4....0,9).

- For the quick correction of bracket bonding failures, even in the mouth, because parallelism of the wire remains.
- For bending 0,4-0,9 mm steps (SD 105/0,4...0,9)

- Tungsten-Carbide insert.
- For quickly and safely creating a tip into steel wire only, even inside the mouth.
- The line and the parallelism of the arch won’t change.
- Using it in in-out direction we can get an extra rotational bend.
- Avaliable in Upper Left (SD 110/4...20/UL) and Upper Right (SD 110/4...20/UR) versions.
- We produce it 4-20 degrees; usually 2 pliers are enough (4-20)

- Particular radius for the thin and the thick wires.
- A quick and simple tool for bending the front arches.
- The precise design excludes the appearance of undesired torque.